Generally, when we dismantle and replace the new conveyor belt of our mesh belt conveyor, we should dismantle and replace the new supporting point guide rail and transmission gear together. Carelessness in one or more of them will increase the damage of the mesh belt conveyor components. This leads to reduced application deadlines for parts. Let’s talk to everyone about the daily difficult inspections of mesh belt conveyors:

　　 1. Check whether the conveyor belt of the mesh belt conveyor is abnormally damaged or destroyed.

　　2. Use conveyor belt support force adjustment equipment to check whether the support force of the support force adjuster is too much, and must not exceed the energy borne by the conveyor belt.

　　3. All supporting point rollers can successfully rotate.

　　4. Check whether the wheels of the mesh belt conveyor are excessively damaged.

　　5. Whether there is dirt in the middle of the transmission gear and the conveyor belt, it must be clean and tidy.

　　6. ​​Whether the transmission is in a detailed integration of the passive shaft and the conveyor belt.

　　7. Is everything normal at all the moisturizing positions?

　　 8. The position where all the software of the mesh belt conveyor system must be cleaned up.
　　 believes that the output power balance in the liquid viscous automatic control system is only suitable for the ideal long-distance multi-point decentralized drive mesh belt conveyor with average raw materials, continuous, and not complicated terrain and working conditions. Following the frequent development trend of mesh belt conveyors, we summarize practical work experience. In recent years, we have accompanied the development of cost-effective soft starters. Automatic control systems using soft starters have gradually been generally used in long-distance multi-point decentralized drive networks with different characteristics. The conveyor belt transportability of the belt conveyor using the soft starter can complete many different functions such as slow operation, slow stop, light load and low damage operation, and low speed gear belt inspection.

Regarding the use of soft starters with a little more long-distance decentralized drive, select the speed master-slave relationship control, that is, select the top head drive as the dominant drive, send the speed output to the top head drive, and load the instant speed of the top head drive to The intermediate drive and the end drive are given as rates, or the instantaneous rate loaded into the intermediate drive is sent to the end drive.

In the early stage of its adjustment, if the motor rated speed ratio, reducer transmission ratio and drive drum diameter size, and the operation sequence and time manipulation are wrong, the conveyor belt will be surging in a certain period of low support force deposition or It's a streamer. After searching for a suitable preparation, the question type will still arise during the temporary operation of machinery and equipment due to the different damage levels of the drive drums.